Port-Track Enable - Cisco MDS 9000 series Command Reference Manual

Chapter 18 P Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

port-track enable

To enable port tracking for indirect errors, use the port-track enable command in configuration mode.
To disable this feature, use the no form of the command.
Syntax Description
This command has no other arguments or keywords.
Defaults
Disabled.
Command Modes Configuration mode.
Command History Release
2.0(x)
Usage Guidelines
The software brings the linked port down when the tracked port goes down. When the tracked port
recovers from the failure and comes back up again, the tracked port is also brought up automatically
(unless otherwise configured).
Examples
The following example shows how to enable port tracking.
switch# config terminal
switch(config)# port-track enable
The following example shows how to disable port tracking.
switch# config terminal
switch(config)# no port-track enable
Related Commands Command
show interface fc
show interface
port-channel
OL-8413-07, Cisco MDS SAN-OS Release 3.x
port-track enable
no port-track enable
Modification
This command was introduced.
Description
Displays configuration and status information for a specified Fibre Channel
interface.
Displays configuration and status information for a specified PortChannel
interface.
Cisco MDS 9000 Family Command Reference
port-track enable
18-25