Npv Enable - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

npv enable

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
npv enable
To enable N Port Virtualization (NPV), use the npv enable command in configuration mode. To disable
this feature, use the no form of the command.
Syntax Description This command has no other arguments or keywords.
Defaults
None.
Command Modes Configuration mode.
Command History Release
3.2(1)
Usage Guidelines
When NPV is enabled, all configurations are erased and the switch is rebooted. The switch restarts in
the NPV mode. All configuration and verification commands for NPV are available only when NPV is
enabled on the switch. When you disable this feature, all related configurations are automatically erased
and the switch is rebooted.
Examples The following example shows how to enable NPV.
switch# config
switch(config)# npv enable
Related Commands Command
show npv status
Cisco MDS 9000 Family Command Reference
16-8
npv enable
no npv enable
Modification
This command was introduced.
Description
Displays the NPV current status.
Chapter 16 N Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x