Fcroute - Cisco MDS 9000 series Command Reference Manual

fcroute

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
fcroute
To configure Fibre Channel routes and to activate policy routing, use the fcroute command. To remove
a configuration or revert to factory defaults, use the no form of the command.
Syntax Description
fcid
network-mask
interface
fc slot/port
port-channel port
domain domain-id
metric number
remote
vsan vsan-id
policy fcroute-map
route-map-identifier
Defaults None.
Command Modes
Configuration mode.
Command History Release
1.0(2)
3.0(3)
Usage Guidelines Use this command to assign forwarding information to the switch and to activate a preferred path route
map.
Examples
The following example specifies the Fibre Channel interface and the route for the domain of the next hop
switch for VSAN 2.
switch# config terminal
Cisco MDS 9000 Family Command Reference
8-38
fcroute {fcid network-mask interface {fc slot/port | port-channel port} domain domain-id {metric
number | remote | vsan vsan-id} | policy fcroute-map vsan vsan-id [route-map-identifier]}
no fcroute {fcid network-mask interface {fc slot/port | port-channel port} domain domain-id
{metric number | remote | vsan vsan-id} | policy fcroute-map vsan vsan-id
[route-map-identifier]}
Specifies the FC ID. The format is 0xhhhhhh.
Specifies the network mask of the FC ID. The format is 0x0 to 0xffffff.
Specifies an interface.
Specifies a Fibre Channel interface.
Specifies a PortChannel interface.
Specifies the route for the domain of the next hop switch. The range is 1 to
239.
Specifies the cost of the route. The range is 1 to 65535. Default cost is 10.
Configures the static route for a destination switch remotely connected.
Specifies a VSAN ID. The range is 1 to 4093.
Activates policy routing.
Specifies the route map identifier. The range is 1 to 65535.
Modification
This command was introduced.
Added the policy option.
Chapter 8 F Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x