Tacacs-Server Timeout - Cisco MDS 9124 - Fabric Switch Reference

tacacs-server timeout

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
tacacs-server timeout
To specify the time between retransmissions to the TACACS+ servers, use the tacacs-server timeout
command. You can revert the retransmission time to its default by issuing the no form of the command.
Syntax Description
seconds
Defaults None.
Command Modes
Configuration mode.
Command History Release
1.3(2)
Usage Guidelines This command is only available when the TACACS+ feature is enabled using the tacacs+ enable
command.
Examples The following example configures the TACACS+ server timeout value.
switch# config terminal
switch(config)# tacacs-server timeout 30
Related Commands Command
show tacacs-server
tacacs+ enable
Cisco MDS 9000 Family Command Reference
23-12
tacacs-server timeout seconds
notacacs-server timeout seconds
Specifies the time (in seconds) between retransmissions to the RADIUS
server. The default is one (1) second and the valid range is 1 to 60 seconds.
Modification
This command was introduced.
Description
Displays TACACS+ server information.
Enable TACACS+.
Chapter 23
OL-16217-01, Cisco MDS SAN-OS Release 3.x
T Commands