Cdp Enable - Cisco Nexus 5500 Series Command Reference Manual

Chapter C Commands

cdp enable

To enable the Cisco Discovery Protocol (CDP) on an interface, use the cdp enable command. To disable
CDP on the interface, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Default None
Command Modes Interface configuration mode
Virtual Ethernet interface configuration mode
Command History Release
5.2(1)N1(1)
Usage Guidelines
You can use this command on the following interfaces:
•
•
•
Examples This example shows how to enable CDP on an Ethernet interface:
switch# configure terminal
switch(config)# interface ethernet 1/1
switch(config-if)# cdp enable
This example shows how to enable CDP on a specific virtual Ethernet interface:
switch# configure terminal
switch(config)# interface vethernet 1
switch(config-if)# cdp enable
This example shows how to disable CDP on a specific virtual Ethernet interface:
switch# configure terminal
switch(config)# interface vethernet 1
switch(config-if)# no cdp enable
OL-27880-02
cdp enable
no cdp enable
Modification
This command was introduced.
Ethernet interface
Management interface
Virtual Ethernet interface
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
cdp enable
113