Adjusting Snmp Notification Settings Of Lldp Changes; Specifying A Management Address For The Lldp Management Tlv; Configuring Lldp (J-Web Procedure) - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Adjusting SNMP Notification Settings of LLDP Changes

Specifying a Management Address for the LLDP Management TLV

Related
Documentation

Configuring LLDP (J-Web Procedure)

Copyright © 2010, Juniper Networks, Inc.
You can adjust the following settings for SNMP notifications of LLDP changes. If the
values are not specified or the interval values are set to
To specify the frequency at which LLDP database changes are sent (in seconds):
[edit protocols lldp]
user@switch# set lldp-configuration-notification-interval 600
To specify the frequency at which changes in topology global statistics are sent (in
seconds):
[edit protocols lldp]
user@switch# set ptopo-configuration-trap-interval 600
To specify the holding time (used in combination with the
ptopo-configuration-trap-interval
global statistics are held before they are is discarded (in seconds):
[edit protocols lldp]
user@switch# set ptopo-configuration-maximum-hold-time 2147483647
You can configure an IP management address to be used in the LLDP Management type,
length, and value (TLV).
To configure the management address:
[edit protocols lldp]
user@switch# set management-address 192.168.0.0
Configuring LLDP (J-Web Procedure) on page 2843
Configuring LLDP-MED (CLI Procedure) on page 2844
Understanding 802.1X and LLDP and LLDP-MED on EX Series Switches on page 2759
Use the LLDP Configuration page to configure LLDP global and port settings for an EX
Series switch on the J-Web interface.
To configure LLDP:
Select >
Configure Switching
1.
The LLDP Configuration page displays LLDP Global Settings and Port Settings.
The second half of the screen displays operational details for the selected port.
Chapter 89: Configuring Access Control
, the notifications are disabled.
0
value) to determine the length of time that topology
> .
LLDP
2843