Delta AS Series Programming Manual page 878

Explanation
1. Operands used in this instruction are described below:
S: Daylight saving time function codes
Firmware version before V1.04 (V1.04 excluded) supports the following function codes:
Function codes
0
1
2
3~
Firmware version after V1.04 (V1.04 included) supports the following function codes:
Function codes
0
1
2
3
4
5
7
6, 8~
Note 1: When the code in S is 4, 5 or 7, the execution of instruction is of no use.
Note 2: Read more for information on the various modes in the following sections.
S : setting for the month to start daylight saving time
1
S : setting for the date to start daylight saving time
2
S=1 (daylight saving time mode 1 enabled), S
S=3 (daylight saving time mode 2 enabled), S
weekday of S
2
S : setting for the month to end daylight saving time
3
S : settings for the date to end daylight saving time
4
S=1 (daylight saving time mode 1 enabled), S
Disable daylight saving time
Enable daylight saving time mode 1
Read daylight saving time
Reserved or viewed as reading daylight saving time
Disable daylight saving time
Enable daylight saving time mode 1
Read daylight saving time
Enable daylight saving time mode 1
Disable daylight saving time (set by the system)
Daylight saving time mode 1 enabled (set by the system)
Daylight saving time mode 2 enabled (set by the system)
Reserved or viewed as reading daylight saving time
settings for the date to start daylight saving time
2:
settings for the week to start daylight saving time, S
2:
settings for the date to end daylight saving time
4:
Ch ap te r 6 Ap pl ie d Instruc ti ons
Description
Description
6_
+1: on which
2
6 - 5 9 9