Delta AS Series Programming Manual page 795

AS Ser ies Pro gra mm in g M anu al
16. Comps(supposing D100), ActionS (supposing D200), YnoS (supposing D300), and the value in CmpLen is 6.
CurNo
1
2
3
4
5
6
17. Executing the instruction (En OFF  ON) and set the Update to ON. Once the values are updated, the instruction
uses the updated values for comparison. The current number less than the corresponding value in Compsis set for
comparison. For instance, if the current value is 3500 when the instruction is executed, the corresponding CurNo is 3
and the number 1~3 (counter value 3000 < current value 3500) are set for comparison. The action set is Y0.0 = ON +
interrupt I400 request, Y0.1 = ON + interrupt I401 request, Y0.0 = toggle between ON and OFF) + interrupt I402
request, and the value in CurNo is 3.
18. If En ON  OFF, it indicates the comparison output function is disabled. The states of CurNo and Output stop
updating. The counter continues to count but no comparison is made.
19. Refer to the following table for more details when any of the Error flag is ON.
_6
ErrCode
16#1400
16#1401
16#1402
16#1403
16#1404
16#1405
16#1406
16#1408
16#1409
16#140C
16#1413
16#1416
6-516
CompS
Source value for
comparison (32-bit)
D100 = 1000
D102 = 2000
D104 = 3000
D106 = 4500
D108 = 5500
D110 = 6500
This function is NOT available for this module.
The value is invalid or out of range.
No response from the module. Communication timeout.
HWCONFIG configuration error. Instruction stops.
There is no such counting channel for the HC module.
Input interface not selected. Instruction stops.
Invalid value in Action
Incorrect order in the value of CompS
Invalid value in Yno
Invalid value in CmpLen
One of the counting channel of the HC module is executing output. Other channels cannot perform
the same task at the same time.
Invalid value in InoS
ActionS
To take when the (output point
value is met
D200 = 2 (On) D300 = 0 (Y0.0)
D201 = 2 (On) D301 = 1 (Y0.1)
D202 = 3 (Toggle) D302 = 0 (Y0.0)
D203 = 2 (On) D303 = 2 (Y0.2)
D204 = 1 (Off) D304 = 3 (Y0.3)
D205 = 1 (Off) D305 = 1 (Y0.1)
Description
YnoS
InoS
(interrupt number)
number)
D400 = 400 (I400)
D401 = 401 (I401)
D402 = 402 (I402)
D403 = 403 (I403)
D404 = 404 (I404)
D405 = 405 (I405)