Delta AS Series Programming Manual page 1090

2. The following table explains UDP connection errors.
Error Code
(SR180)
16#2003
16#600C
16#600D
16#6209 UDP Socket error flag
16#620A UDP Socket error flag
16#620C UDP Socket error flag
16#620D UDP Socket error flag
16#620E UDP Socket error flag
16#620F UDP Socket error flag
16#6210 UDP Socket error flag
16#6211 UDP Socket error flag
16#6213 UDP Socket error flag
16#6215 UDP Socket error flag
16#6217 UDP Socket error flag
16#6218 UDP Socket error flag
16#621A UDP Socket error flag
3. When the client and server are both AS Series PLC and the communication timeout settings are set the same, the
server automatically cuts the connection if a timeout occurs on the server first. In this case, the error flag on the
client is not ON. On the other hand, if a timeout occurs on the client first, the error flag on the client is ON and the
connection is cut.
Error Flag
SM0 S , S , or S
1 2
SM1109 Local socket used
SM1100 Ethernet network not connected
Illegal IP address
Illegal communication mode
Illegal address for sending data
Length of sent data exceeds the range
Source data device exceeds the range
Illegal address for receiving data
Length of data received exceeds the range
Target data device exceeds the range
Size of data received larger than dataset
UDP Socket not connected
UDP Socket connection triggered
Sending of data through UDP Socket triggered
Disabling UDP Socket connection triggered
Ch ap te r 6 Ap pl ie d Instruc ti ons
Description
exceeds the range
3
6_ 6
6 - 8 11