Delta AS Series Programming Manual page 687

AS Ser ies Pro gra mm in g M anu al
Parameter
0
1
2
3
4
5
6
7
18
19
42
43
44
46
_6
2. n is the setting value of data length. The range of the setting value is 1~256. If the input value exceeds the range,
the PLC will execute the instruction at the minimum or maximum value.
3. The conversion modes and move modes are explained as below.

When m=0:
If n=4, the 8-bit data is converted into the 16-bit data (high 8-bits, low 8-bits), the conversion is as the
following figure shows.
6 - 4 0 8
8-bit data converted into 16-bit data (high 8 bits, low 8 bits)
8-bit data converted into 16-bit data (low 8 bits, high 8 bits)
16-bit data (high 8 bits, low 8 bits) converted into 8-bit data
16-bit data (low 8 bits, high 8 bits) converted into 8-bit data
8-bit hex data (high 4 bits, low 4 bits) converted into ASCII data
8-bit hex data (low 4 bits, high 4 bits) converted into ASCII data.
8-bit ASCII data converted into hex data (high 4 bits, low 4 bits).）
8-bit ASCII data converted into hex data (low 4 bits, high 4 bits).
String-type data converted into floating-point data (available for FW V1.08 or later)
Floating-point data converted into string-type data (available for FW V1.08 or later)
Caculate the duration of 2-Axis relative-position clockwise arc interpolation
Caculate the duration of 2-Axis relative-position counterclockwise arc interpolation
Set up the built-in input points filtering time for the PLC
Caculate the relative -position pulse output time in acceleraton and deceleration (available for FW
V1.08 or later)
Hi-byte Lo-byte Hi-byte Lo-byte
 
 
 
 
Description
Hi-byte Lo-byte Hi-byte Lo-byte
   
   