Delta AS Series Programming Manual page 1216

Example (Ladder diagrams)
1. Draw a rhombus as shown below.
(-2 7000, -270 00)
2. Steps:

Set the coordinates of four points (0, 0), (-27000, -27000), (0, -55000), (27000, -27000) as in the figure
above. Calculate the relative coordinates of the four points and obtain (-27000, -27000),
(27000, -28000), (27000, 28000), and (-27000, 27000). Place them in the 32-bit registers (D200, D202), (D204,
D206), (D208, D210), (D212, D214).

RUN the program in the PLC. Set M0 to ON to start the 2-axis line drawing.
Cha p ter 6 App l ied Ins truc tio ns
Y軸
(0, 0)
X軸
(27 000, -27000 )
(0,-5 5000)
6_
6 - 9 3 7