Delta AS Series Programming Manual page 879

AS Ser ies Pro gra mm in g M anu al
S=3 (daylight saving time mode 2 enabled), S
weekday of S
S : settings for the change due to daylight saving time; unit: minute
5
D: stores the state of the daylight saving time; when the value in D is OFF, daylight saving time is disabled. When the
value in D is ON, daylight saving time is enabled.
2. Descriptions on the value in function code S for daylight saving time functions
D.S.T State
Disabled
Enabled
Read
• Disabled daylight saving time function (refer to example 1 below)
When the operand S is 0, the function of daylight saving time is disabled. When S is set to disable the daylight
saving time, the values in S
• Enabled daylight saving time function (refer to example 2 and 3)
When the value in S is 1 or 3, daylight saving time function is enabled: S
daylight saving time; S
due to daylight saving time; unit: minute; the operand D shows the daylight saving time state. When the
function of daylight saving time is enabled and the system runs for the first time during the start time (S
_6
the system time adds the value set in S
system runs for the first time during the end time (S
Modes for daylight saving
6 - 6 0 0
4
S Function Code
0
1, 3
2
–S
are irrelevant and the operand D shows the daylight saving time state as OFF.
1 5
and S : setting for the month to end daylight saving time; S
3 4
Mode S Function Code
Mode 1 1
Mode 2 3
settings for the week to end daylight saving time, S
4:
Description
Disabled daylight saving time function
Enabled daylight saving time function
Read the daylight saving time setting
once. When the function of daylight saving time is disabled and the
5
, S ), the system time subtracts the value set in S
1 2
Rules
By month and date
By month and week
+1: on which
2
and S : setting for the month to start
1 2
: settings for the change
5
Available for
V1.00 or later
V1.04 or later
, S ),
1 2
once.
5