Delta AS Series Programming Manual page 1207

AS Ser ies Pro gra mm in g M anu al
If S =-1 or < 0 after the mark signal is received
6
If the setting value of S
ramp-down stop within the ramp-down time,
If S is greater than the number of pulses output within
6
the ramp-down time,
9. For PLC with FW V1.06.00 (V1.06.00 included) or later: If S
that the ramp-down stop is performed based on the ramp-down time. If S
received, it means that the output immediately stops. If S
setting value of S
the target frequency and performs the ramp-down stop in accordance with the set ramp-down time. If S
than the number of pulses output within the ramp-down time, the instruction outputs the number of redundant
pulses with the same output frequency when the interrupt is triggered, and then performs the ramp-down process.
S : the number of output pulses in the ramp-down
6
If S = > 0 after the mark signal is received
6
_6
If the setting value of S
ramp-down stop within the ramp-down time,
If S = > 0 after the mark signal is received
6
If S is greater than the number of pulses output within
6
the ramp-down time,
If S is set to 0 after the mark signal is received
6
If S =-1 after the mark signal is received
6
If S =< -1 after the mark signal is received
6
If the setting value of S
ramp-down stop within the ramp-down time,
If S =< -1 after the mark signal is received
6
6 - 9 2 8
is not enough to achieve the
6
is not enough to achieve the ramp-down stop within the ramp-down time, the instruction limits
6
is not enough to achieve the
6
is not enough to achieve the
6
the output immediately stops
The instruction limits the target frequency and
performs the ramp-down stop in accordance with the
set ramp-down time
The instruction outputs the number of redundant
pulses with the same output frequency when the
interrupt is triggered, and then performs the ramp-
down process
is set to 0 after the mark signal is received, it means
6
is set to -1 after the mark signal is
6
is set to >0 after the mark signal is received and if the
6
Description
The instruction limits the target frequency and
performs the ramp-down stop in accordance with the
set ramp-down time
The instruction outputs the number of redundant
pulses with the same output frequency when the
interrupt is triggered, and then performs the ramp-
down process
The ramp-down stop is performed based on the ramp-
down time
The output immediately stops
The instruction does NOT limit the target frequency
and after outputting the number of output pulses, the
output stops immediately
The instruction outputs the number of redundant
pulses with the same output frequency when the
is greater
6