Delta AS Series Programming Manual page 583

AS Ser ies Pro gra mm in g M anu al
API Instruction
1014 D
Device X
HCno
CmpLen
CmpS
Action
Yno
CurNo
Data
type
HCno
CmpLen
CmpS
Action
Yno
CurNo
Symbol
_6
Explanation
1. This instruction is available for FW V1.06.10 or later.
2. HCno: If the counter is a general one, the comparison will not begin even when the timing to execute comparison is
reached. The comparison begins only when the instruction is scanned. If the counter is a high-speed one, the
comparison begins when the timing to execute comparison is reached, not affected by the PLC scan cycle. Refer to
DHSCS instruction for more details on the usage and the restriction of the high-speed number.
3. CmpLen: To select a set of groups for comparison. The set group compares in a cyclic manner. The setting value of
the group can be between 4 and 32. If the setting value exceeds the acceptable range, this instruction is not
executed. And SM0 will be switched to ON. Error code SR0: 0x200B.
6 - 3 0 4
HSCY
Y M S T C





： 32-bit input counter number
HCno
CmpLen ： The length of data to be compared
： The source value of data in 32-bit to be compared
CmpS
Action ： Action to be taken when the comparison is made.
： The number of Y output point
Yno
CurNo ： The current group number that is making the comparison
Operand
HCno ~ CurNo
HC D FR SM SR


  
 
 






Pulse Instruction
－
Description
Cyclic counting, comparing and outputting
E K 16#
 
16-bit instruction 32-bit instruction
－
"$" F

AS