Delta AS Series Programming Manual page 1220

Example
1. Draw a rhombus as in the figure below.
2. Steps:

Set the four coordinates (-27000, -27000), (0, -55000), (27000, -27000) and (0, 0) as in the
figure above. Place them in the 32-bit registers (D200, D202), (D204, D206), (D208, D210),
(D212, D214).

RUN the program in the PLC. Set M0 to ON to start the 2-axis line drawing.
A xis Y
(0,0)
(-27,000, -27,000)
(0, -55,000)
Cha p ter 6 App l ied Ins truc tio ns
Axis X
(27,000, -27,000)
6_
6 - 9 4 1