Delta AS Series Programming Manual page 1168

3.
D only allows Y0.0–Y0.11 as the pulse output device.
4.
There is no limit to how many times you can use the instruction a program. But only one output instruction that uses
the same output point can be executed in the same scan cycle. When several high-speed pulse output instructions
start the same output point in the program, the PLC first performs the output based on the instruction that is executed
first.
5. ≦0 or S ≦0, it is processed as 0 (the pulse output is OFF). If S
If S
1 2
and S is not 0, the pulse output is always ON.
2
6.
You can modify the pulse output width S
7.
The relevant special registers SR are listed in the following table.
Output point number
Present output
#1
position
（32-bit）
Output point number
Present output position
#1
（32-bit）
#1：All present output positions are latched when power is off.
8.
Refer to Example 3 from the DJOG instruction (API 2703) for programming in ST language.
Example
When X0.0 is ON, Y0.1 outputs the following pulses. When X0.0 switches to OFF, Y0.1 output changes to OFF.
t=1000ms
Output Y0.1
Output Y1
T=2000ms
and pulse output cycle S
1
Attribute Y0.0 Y0.1
SR460 SR474
R/W
SR461 SR475
Attribute Y0.6 Y0.7
SR520 SR534
R/W
SR521 SR535
Cha p ter 6 App l ied Ins truc tio ns
＞S
it is processed as S
1 2,
when the PWM instruction is executed.
2
Y0.2 Y0.3 Y0.4
SR480 SR494 SR500
SR481 SR495 SR501
Y0.8 Y0.9 Y0.10
SR540 SR554 SR560
SR541 SR555 SR561
＝S ＝S
When S
1 2. 1 2
Y0.5
SR514
SR515
Y0.11
SR574
SR575
6_
6 - 8 8 9