Delta AS Series Programming Manual page 1189

Hide thumbs Also See for AS Series:

Table of Contents

AS Ser ies Pro gra mm in g M anu al

Ramp-down time

Target frequency of

the fixed slope

Present output

Note: R mean the device is readable. W means the device is writable. Wd means the device is writable any time

except when performing the high-speed output.

After output completion auto-reset is enabled, the flag is automatically reset to OFF when the output completes.

You must set the flag to ON again if the auto-reset function is needed for the next output operation. It is suggested

that you use the rising-edge or falling-edge to trigger the flag every time. The function is usually used when the

output DDRVI instruction cannot be scanned and executed by PLC program after DDRVI is executed. For

example, when the instruction is executed in an interrupt program.

If you use the Completion flag to set the I interrupt function, the flag is automatically reset to OFF when the output

completes and the interrupt program starts. You must set the flag to ON again for the next output in which the

interrupt occurs. It is suggested that you use the rising-edge or falling-edge to trigger the flag every time.

When the direction outputs are not using the default outputs to output, you can refer to the table below for setting

up the time for directional outputting goes first before pulse outputting. So that you can be sure the outputting only

happens when switching to the direction outputs. The unit for SR is millisecond and the range is 0-20 ms. Default is

0, indicating inactive.

Output point for D

Output point for D

Note: the time source here is from PLC scan time. (available for firmware version 1.02.20 or later)

Show Quick Links

Table of Contents

Troubleshooting