Delta AS Series Programming Manual page 780

Hide thumbs Also See for AS Series:

Table of Contents

This instruction is for AS02HC-A only. You can start, stop the counter as well as set up and edit the counter value.

This instruction is available for PLC with FW V1.08.or later and ISPSoft V3.10 or later.

Before executing this instruction, you need to set up DOdata. Once En is activated, the PLC scans the values in

DOdata immediately. DOdata is the initial status of the output points Y0.0 ~ Y0.3. If you need to change the status of

the output point, you need to set new values in DOdata and set the Update to ON. Once the values in DOdata is

updated, the Update switches to OFF.

Module: The module number that is connected to the right side of PLC directly or connected to the remote module

that acts as PLC, e.g. the first connected module is module number 1, the second connected module is module number

2. Up to 32 modules can be connected and counted and each type of modules should be included in the count.

Module ~ ErrCode

Pulse Instruction

Module ： Module number

Update ： Channel number

DOdata ： Digital output data

DOstat ： Digital output state

ErrCode ： Error code

Cha p ter 6 App l ied Ins truc tio ns

HC module digital output point

16-bit instruction

： Error flag

32-bit instruction

Show Quick Links

Table of Contents

Troubleshooting