Delta AS Series Programming Manual page 745

AS Ser ies Pro gra mm in g M anu al
(High Word). Once the execution of this instruction started, the value of TWeight is sent to the LC module for
calibration. You cannot change the value of TWeight after the instruction is executed. the value of the first point for
calibration weight should be 0 (zero correction). If not, the Error flag will be ON.
9.
Once ADone changes from OFF to ON, the entire calibration will be stopped. The calibration can be performed again
if the LCCAL instruction is enabled again after disabled.
10.
CPoint is the number of points which have been calibrated and can not be modified by users. When CPoint value >=
TPoint value, the calibration is considered to be completed and the ADone flag changes to ON.
11.
When the LCCAL instruction is enabled initially, the CPoint value is automatically cleared to 0 and Trigger, Done
and ADone change to OFF and the calibration is prepared. After Trigger is set from OFF to ON and the LC module
completes the calibration, the value of CPoint will be automatically added by 1 and the Done flag changes to ON.
You can observe current points for which the calibration has been completed via the value. For example, as the
CPoint value is 2, it means that Trigger is triggered twice and the module has completed the 2-point calibration.
12.
The error codes that ErrCode shows are listed in the following table.
Error code
16#1410
16#1411
16#1412
16#1413
16#1414
_6
16#1415
16#1416
16#1417
16#1418
13.
See the sequence diagram in a calibration example.
6-466
Error in the LC group number or module number
The LC module has no such channel number
LC module writing error or communication timeout
The LC module has completed the calibration. Disable the instruction and retrigger it.
The first value for calibration weight is not 0.
The calibration weight value is not a floating-point value.
The value exceeds the measuring range.
The value exceeds the weight limit.
Calibration error
Description