Delta AS Series Programming Manual page 712

Additional remarks
1. If the values in m and m
1
ON, and the error code in SR0 is 16#2003.
2. If D -D +n-1 exceed the device range, the instruction is not executed, SM0 is ON, and the error code in SR0 is
1 1
16#2003.
3. If the value in n exceeds the range, the operation error occurs, the instruction is not executed, SM0 is ON, and the
error code in SR0 is 16#200B.
4. Due to the fact that the TO instruction decreases the execution efficiency of both the CPU module and the I/O
module, it is suggested that you use the pulse type instruction to perform a single trigger as in the example shown
above.
5. If there is any error response from the modules, the instruction stores the error code in D
descriptions are shown in the following table.
Error code
16#1400
16#1401
16#1402
exceed their range, an operation error occurs, the instruction is not executed, SM0 is
2
Attempted to read the data from the control register (CR) in the module but no such CR
number exists.
The value is not valid for the module.
The module is not responding, communication timeout.
Cha p ter 6 App l ied Ins truc tio ns
. The error code
2
Description
6_
6-433