Delta AS Series Programming Manual page 461

Hide thumbs Also See for AS Series:

Table of Contents

AS Ser ies Pro gra mm in g M anu al

Instruction code

This instruction uses seconds as the unit of time. The time for which a button switch has been turned ON is

multiplied by n, and the product is stored in D. D+1 is for system use only. When the instruction is executed, the

value in D+1 cannot be altered. Otherwise, the time is counted incorrectly.

When the conditional contact is ON, D is reset to 0.

Setting the multiplier: when n is 0, D uses a second as the timing unit. When n is 1, the time for which the button

switch has been turned ON is multiplied by 10, and D uses 100 milliseconds as the timing unit. When n is 2, the

time for which the button switch has been turned ON is multiplied by 100, and D uses 10 milliseconds as the timing

unit. The greater the value in n, the higher the timing resolution.

When you use on-line editing, reset the conditional contact to initialize the instruction.

The value in n must be between 0–2.

K0 (unit: 1 second)

K1 (unit: 100 milliseconds)

K2 (unit: 10 milliseconds)

Pulse instruction

16-Bit instruction

D ： Recorded time

： Multiplier

Teach mode timer

32-Bit instruction

Show Quick Links

Table of Contents

Troubleshooting