Delta AS Series Programming Manual page 502

API Instruction code
0710 YOUT
Device X Y M
S
1
S
2
S
3
 
D
Data
type
S
1

S
2
S
3

D
Symbol
Explanation
1. This instruction is only available for AS Series PLCs with firmware version 1.04.00 or higher. The instruction cannot
be used in the ST programming language, interrupt tasks or function block which is called only once.
2. S is for the setting of the high-speed counter. Use the same settings for the high-speed counter as for the high-
1
speed counter for the XCMP instruction.
3. S occupies two consecutive 16-bit devices. S
2
of objects). The range for n and m is between 1–32 for PLC with FW V1.04.00 (V1.04.00 included) or previous
versions. And the range for n and m is between 1–64 for PLC with FW V1.06.00 (V1.06.00 included) or higher
versions. When the value is out of range, the value used is the maximum (32) or the minimum (1). The settings for
the operands should be the same as for the XCMP instruction.
4. S is first corresponding device for the comparison result in the stack area. S
3
devices and 2xmxn consecutive 32-bit devices (or 4xmxn consecutive 16-bit devices). For information on the
functions of each device and the corresponding number for D, refer to the XCMP instruction (API 0709). It is
suggested that you use the same variable as you use for the XCMP instruction.
Operand
，S ，S
S
1 2
S T C HC



Pulse instruction
： High-speed counter number
S
1
Setting for the number for work
：
S
2
stations and objects
First corresponding device for the
：
S
3
comparison result in the stack area
First corresponding device for the
：
D
output work station
+0 is n (the work station number) and S
2
Ch ap te r 6 Ap pl ie d Instruc ti ons
Comparing the outputs of multiple work
，D
3
D FR SM SR



16-Bit instruction
－
AS
3
Function
stations
E K 16# "$"

32-Bit instruction
－
+1 is m (the maximum number
2
occupies 2xn consecutive 16-bit
6 - 2 2 3
F
6_