Delta AS Series Programming Manual page 739

AS Ser ies Pro gra mm in g M anu al
11.
The error codes that ErrCode shows are listed in the following table.
Error code
16#1400
16#1401
16#1402
16#1403
16#1404
16#1405
16#1406
16#1407
12.
When the DPUMPG instruction is enabled or disabled, the PLC will have to notify the module to enable or disable
the high-speed counter function. Thus the instruction can not be used with API1410 DPUCNT together. Otherwise it
may occur that the two instructions enable or disable the counting of the module with each other.
_6
6-460
The module does not support the function.
The data stored in the module is illegal or exceeds the allowed range.
There is no response from the module; communication timeout occurs.
There is no such output axis number in the PU module.
The output frequency of the PU module is illegal.
The output axis specified by the PU module is outputting data. It is not allowed to
specify the output repeatedly.
PU module stops Output pulse when the positive limit is reached.
PU module stops Output pulse when the negative limit is reached.
Description