Delta AS Series Programming Manual page 463

AS Ser ies Pro gra mm in g M anu al
API Instruction code
0702
Device X
S

m
D
Data
type
S
m

D
Symbol
Explanation
_6
1. This instruction generates timing for the off-delay relay, the one-shot circuit, and the flashing circuit.
2. This instruction uses 100 milliseconds as the timing unit. If the setting value for m is 50, the time value is 5
seconds.
3. You cannot use this timer repeatedly.
4. D occupies four consecutive devices.
5. Before the instruction is executed, reset D-D+3.
6. When the conditional contact is not enabled and the value of the device meets one of the two conditions mentioned
below, D, D+1, and D+3 are ON for m seconds before they are switched OFF. When the conditional contact is not
enabled and the value of the device does not meet either of the two conditions mentioned below, D-D+3 keep OFF.

The value of the timer is less than or equal to m, D is ON, and D+1 is OFF.

The value of the timer is less than m, D +2 is OFF, and D, D+1, and D+3 are ON.
7. When the on-line editing is used, Reset the conditional contact to initialize the instruction.
8. The value in m must be between 1–32767.
6 - 1 8 4
STMR
Y M S T C


  

Operand
S, m, D
HC D FR SM
 
 

Pulse instruction 16-Bit instruction
－
： Timer number (T0-T511)
S
m ： Setting value of the timer
： Output device
D
Function
Special timer
SR E K 16# "$"
  

32-Bit instruction
－
AS
F