Ripng Summary-Address - HP 6125XLG Command Reference Manual

Blade switch layer 3 - ip routing
Table of Contents

Advertisement

Default
The split horizon function is enabled.
Views
Interface view
Predefined user roles
network-admin
Usage guidelines
The split horizon function prevents routing loops. If you want to disable this function, make sure the
operation is indispensable.
If both poison reverse and split horizon are enabled, only the poison reverse function takes effect.
Examples
# Enable the split horizon function on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ripng split-horizon

ripng summary-address

Use ripng summary-address to configure a summary network to be advertised through the interface.
Use undo ripng summary-address to remove the summary.
Syntax
ripng summary-address ipv6-address prefix-length
undo ripng summary-address ipv6-address prefix-length
Default
The summary network to be advertised through the interface is not configured.
Views
Interface view
Predefined user roles
network-admin
Parameters
ipv6-address: Specifies the destination IPv6 address of the summary route.
prefix-length: Specifies the prefix length of the destination IPv6 address of the summary route, in the
range of 0 to 128. It indicates the number of consecutive 1s of the prefix, which defines the network ID.
Usage guidelines
Networks falling into the summary network will not be advertised. The cost of the summary route is the
lowest cost among summarized routes.
Examples
# Assign an IPv6 address with the 64-bit prefix to VLAN-interface 100 and configure a summary with the
35-bit prefix length.
346

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents