Displaying Devices Within The Fabric; Checking The Firmware Version - HP StorageWorks SAN Switch 2/32 Installation Manual

2. At the command line enter the following command:
ipAddrSet
An interactive session is opened and you are prompted for configuration values.
Press Enter to skip over a prompt and leave the parameter value as is.
3. At the Ethernet IP Address prompt, enter the new IP address for the ethernet port
on the switch. Press Enter.
4. At the Ethernet Subnetmask prompt, enter the address of the subnetmask, if
applicable. Press Enter.
5. At the Fibre Channel IP address prompt, enter the Fibre Channel IP address for
the switch. Press Enter.
6. At the Fibre Channel Subnetmask prompt, enter the address of the subnetmask, if
applicable. Press Enter.
7. At the Gateway Address prompt, enter the IP address of the gateway system if
applicable. Press Enter.
The configuration is then committed to the switch firmware.
8. You are then prompted whether to make the IP address changes active now or at
the next reboot. Enter y at the prompt to have the IP address changes take effect
immediately.

Displaying Devices within the Fabric

To verify that you have fabric wide connectivity when you install a new switch,
display the fabric wide device count from the newly installed switch. Use these steps
to display the fabric.
1. Login to the switch as the admin user.
2. At the command line enter the following command:
nsAllShow
This command displays all the connected devices in the fabric.

Checking the Firmware Version

Use these steps to display the SAN Switch 2/32 firmware version.
1. Login to the switch as the admin user.
SAN switch 2/32 version 4.0.x installation guide
Managing the SAN Switch 2/32
3–11 3–11