Igmp-Snooping Version - HP 3600 v2 Series Command Reference Manual

Ip multicast
Hide thumbs Also See for 3600 v2 Series:
Table of Contents

Advertisement

Description
Use igmp-snooping static-router-port to configure the current port as a static router port.
Use undo igmp-snooping static-router-port to restore the default.
By default, no ports are static router ports.
For the HP 3600 v2 EI switches, this command takes effect in both IGMP snooping-enabled VLANs and
VLANs with IGMP enabled on their VLAN interfaces.
For the HP 3600 v2 SI switches, this command takes effect in IGMP snooping-enabled VLANs.
This command does not take effect in a sub-VLAN of a multicast VLAN.
In Layer 2 Ethernet interface view or Layer 2 aggregate interface view, this command takes effect only if
the interface belongs to the specified VLAN.
In port group view, this command takes effect only on those ports in this port group that belong to the
specified VLAN.
Related commands: subvlan.
Examples
# Configure Ethernet 1/0/1 in VLAN 2 as a static router port.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] igmp-snooping static-router-port vlan 2

igmp-snooping version

Syntax
igmp-snooping version version-number
undo igmp-snooping version
View
VLAN view
Default level
2: System level
Parameters
version-number: Specifies an IGMP snooping version, in the range of 2 to 3.
Description
Use igmp-snooping version to configure the IGMP snooping version.
Use undo igmp-snooping version to restore the default.
By default, the IGMPv2 snooping is used.
This command can take effect only if IGMP snooping is enabled in the VLAN.
This command does not take effect in a sub-VLAN of a multicast VLAN.
Related commands: igmp-snooping enable and subvlan.
Examples
# Enable IGMP snooping in VLAN 2, and specify IGMPv3 snooping.
31

Advertisement

Table of Contents
loading

Table of Contents