Receives RIPv1 broadcast and unicast messages, and RIPv2 broadcast, multicast, and unicast
•
messages
When RIPv2 runs on the interface in multicast mode, the interface can perform the following operations:
Sends RIPv2 multicast messages
•
Receives RIPv2 broadcast, multicast, and unicast messages
•
Examples
# Configure VLAN-interface 10 to broadcast RIPv2 messages.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] rip version 2 broadcast
silent-interface (RIP view)
Syntax
silent-interface { interface-type interface-number | all }
undo silent-interface { interface-type interface-number | all }
View
RIP view
Default level
2: System level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
all: Disables all interfaces from sending routing updates.
Description
Use silent-interface to disable an interface or all interfaces from sending routing updates. The interface
only receives but does not send RIP messages.
Use undo silent-interface to restore the default.
By default, all interfaces are allowed to send routing updates.
Examples
# Configure all VLAN interfaces to work in silent state, and activate VLAN-interface 10.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-100] silent-interface all
[Sysname-rip-100] undo silent-interface vlan-interface 10
[Sysname-rip-100] network 131.108.0.0
summary
Syntax
summary
undo summary
54