Configuring The Ftp Client - 3Com Switch 4800G 24-Port Configuration Manual

992 C 80: FTP C
HAPTER
Configuring the FTP
Client
Establishing an FTP
Connection
ONFIGURATION
c
CAUTION:
The FTP function is available when a route exists between the FTP server and
■
the FTP client.
When a device serving as the FTP server logs onto the device using IE, some IE
■
functions are not supported because multiple user connections are established,
and the device supports only one connection currently.
To access an FTP server, the FTP client must connect with it. Two ways are available
for the connection: using the ftp command to establish the connection directly;
using the open command in FTP client view.
Multiple routes may exist for the FTP client to successfully access the FTP server.
You can specify one by configuring the source address of the packets of the FTP
client to meet the requirement of the security policy of the FTP client. You can
configure the source address by configuring the source interface or source IP
address. The primary IP address configured on the source interface is the source
address of the transmitted packets. The source address of the transmitted packets
is selected following these rules:
If no source address of the FTP client is specified, a device uses the IP address of
■
the interface determined by the routing protocol as the source IP address to
communicate with an FTP server.
If the source address is specified with the ftp client source or ftp command,
■
this source address is used to communicate with an FTP server.
If the source address is specified with the ftp client source command and
■
then with the ftp command, the address specified with the latter one is used
to communicate with an FTP server.
The source address specified with the ftp client source command is valid for all
ftp connections and the source address specified with the ftp command is valid
only for the current FTP connection.
Follow these steps to establish an FTP connection (In IPv4 networking):
To do...
Enter system view
Configure the source
address of the FTP client
Exit to system view
Use the command...
system-view
ftp client source { interface
interface-type interface-number |
ip source-ip-address }
quit
Remarks
-
Optional
A device uses the IP address
of the interface determined
by the routing protocol as the
source IP address to
communicate with the FTP
server by default.
-