Displaying And Debugging Ftp Server; Displaying The Source Ip Address Configuration; Introduction To Ftp Client - 3Com 5500-SI Configuration Manual

446 C 22: F S
HAPTER ILE YSTEM
Displaying and
Debugging FTP Server
Displaying the Source IP
Address Configuration
Introduction to FTP
Client
M
ANAGEMENT
After the above configuration, execute
running of the FTP Server configuration, and to verify the effect of the configuration.
Table 490 Display and Debug FTP Server
Operation
Display FTP server
Display the connected FTP users.
The
display ftp-server
information about the current FTP server, including the maximum amount of users
supported by the FTP server and the FTP connection timeout. The
command can be used for displaying the detailed information about the connected
FTP users.
Use the display commands in any view to display the source IP address configuration
for service packets.
Table 491 Display the source IP address FTP Server and Client
Operation
Display the source IP address of the FTP server
Display the source IP address of the FTP client
As an additional function provided by the Switch, FTP client is an application module
and has no configuration functions. The Switch connects the FTP clients and the
remote server and inputs the command from the clients for corresponding operations
(such as creating or deleting a directory).
Configuring Source IP Address for TFTP Service Packets
You can configure source IP address or source interface for the TFTP server and TFTP
client, to enhance service manageability.
Table 492 shows the source IP address configuration tasks.
Table 492 Configure source IP address for service packets
Operation
Enter system view
Use a specified source IP address to
establish a connection with a TFTP
server
Use a specified source interface to
establish a connection with a TFTP
server
Specify source IP address for the TFTP
client
If the ip-addr in the command is not an address of the device, your configuration fails.
If you specify a non-existent interface in the command, your configuration fails.
command in all views to display the
display
Command
display ftp-server
display ftp-user
command can be used for displaying the configuration
Command
display ftp-server source-ip
display ftp source-ip
Command
system-view
tftp tftp-server source-ip ip-addr
tftp tftp-server source-interface
interface-type interface-number
tftp source-ip ip-addr
display ftp-user
Remarks
-
Optional
Optional
Optional