Qe Monitor Overflow-Threshold; Rdram - H3C S7500 Series Command Manual

Command Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches
Examples
# Set the interval for detecting error packets to 50 seconds.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] qe monitor errpkt check-time 50

3.1.19 qe monitor overflow-threshold

Syntax
qe monitor overflow-threshold threshold
View
System view
Parameters
threshold: Integer that sets the overall traffic threshold, ranging from 0 to 4294967295
(in bps).
Description
Use the qe monitor overflow-threshold command to specify the overall traffic
threshold used in queue traffic monitoring.
The overall traffic threshold defaults to 300,000,000 bps (300 Mbps).
With queue traffic monitoring enabled, the switch monitors the queue traffic and
relieves blocks in the output queue of its interfaces.
The criterion used to distinguish a block is that the queue is full and the traffic of the
corresponding interface is less than the specified threshold.
Examples
# Set the overall traffic threshold used in queue traffic monitoring to 90 Mbps.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] qe monitor overflow-threshold 90000000

3.1.20 rdram

Syntax
rdram { enable | disable }
View
System view
Chapter 3 Device Management Commands
3-14