Lldp Admin-Status - H3C MSR Series Command Reference Manual

Table 32 Command output
Field
LLDP tlv-config of port 1
NAME
STATUS
DEFAULT
Basic optional TLV
IEEE 802.1 extended TLV
IEEE 802.3 extended TLV
LLDP-MED extend TLV

lldp admin-status

Use lldp admin-status to specify the LLDP operating mode for a port or all ports in a port group.
Use undo lldp admin-status to restore the default LLDP operating mode.
Syntax
lldp admin-status { disable | rx | tx | txrx }
undo lldp admin-status
Default
The LLDP operating mode is TxRx.
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group view
Default command level
2: System level
Description
Advertisable optional TLVs of port 1.
TLV type.
Indicates whether a specific type of TLV is sent through a port.
Indicates whether a specific type of TLV is sent through a port by
default.
Basic TLVs:
•
Port description TLV.
•
System name TLV.
•
System description TLV.
•
System capabilities TLV.
•
Management address TLV.
IEEE 802.1 organizationally specific TLVs:
•
Port VLAN ID TLV.
•
Port and protocol VLAN ID TLV.
•
VLAN name TLV.
IEEE 802.3 organizationally specific TLVs:
•
MAC-Physic TLV.
•
Power via MDI TLV.
•
Link aggregation TLV.
•
Maximum frame size TLV.
LLDP-MED TLVs:
•
Capabilities TLV.
•
Network Policy TLV.
•
Extended Power-via-MDI TLV.
•
Location Identification TLV.
•
Inventory TLV, including hardware revision TLV, firmware revision
TLV, software revision TLV, serial number TLV, manufacturer
name TLV, model name TLV, and asset id TLV.
140