Ageing-Time - Allied Telesis AR2050V Command Reference Manual

B C
RIDGING OMMANDS
-
AGEING TIME

ageing-time

Overview This command specifies the time period that a learned MAC address will remain
defined within the bridge's MAC address table.
Use the no variant of this command to set the ageing out time back to the default.
Syntax ageing-time <10-1000000>
no ageing-time
Default 300 seconds (5 minutes)
Mode Interface Configuration
Examples To change the ageing time on br2 to 60 seconds (1 minute), use the following
commands:
awplus#configure terminal
awplus(config)#interface br2
awplus(config-if)#ageing-time 60
To reset the ageing time back to its default, use the following commands:
awplus#configure terminal
awplus(config-if)#no ageing-time
To reset the ageing time back to its default, you can also use the following
commands:
awplus#configure terminal
awplus(config-if)#ageing-time 300
Output None
Related bridge
Commands
bridge-group
show bridge
show bridge macaddr
C613-50186-01 Rev B
Parameter
<10-1000000>
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
The number of seconds that the MAC addresses will remain in
the table.
450