Common Filter Configuration Commands - Siemens scalance WLC711 Reference Manual

Example
This example displays information about the current VNS named VNS1:
WLC.siemens.com
WLANS service: wlan4
Non-authenticated: p4
Authenticated: same as non-authenticated
Restrict available role set: disable
Enable status: enable
Synchronize: enable
Name: VNS1

Common Filter Configuration Commands

The commands in this section are common to the configuration of both AP filters and AC filters. Each
filter must be configured in its own context
•
create on page 268
•
config on page 271
•
delete on page 273
•
move on page 273
create
Use the command to create, insert, or append a new filter rule into an AP or AC filter list for a
create
<named-role>. The
and vnsmode:<default-role>:apfilters contexts.
create [pos] proto protocol eth ether-type mac MAC address (ipaddress/mask |
interface-subnet | interface-ip | any) [(port port [port]) | (type-code type
[type])] in (none|src|dst|both) out (none|src|dst|both) (allow | deny | none |
contain2vlan vlan-id) priority (0-7 | none) tos-dscp (0-FF/(FF|FE|FC|F8|F0|E0|C0|
80)|none) cos (named cos|none) traffic-mirror (none) | enable | prohibited)
Parameters
pos
proto protocol
SCALANCE WLC711 CLI Reference Guide
:vnsmode:VNS1# show
(acfilters
command is accessible from within the vnsmode:<default-role>:acfilters
create
Specifies a position value for this filter in the filter list. Valid values are from 0 -
255.
Specifies the protocol for this filter rule by number or name. Valid number values
are from 0 - 255. Valid name values are:
•
udp - UDP protocol
•
tcp - TCP protocol
•
ah - Authentication Header protocol
•
esp - Encapsulating Security Payload protocol
•
any- Any protocol
•
icmp - ICMP protocol
•
gre - Generic Route Encapsulation protocol
•
0-255 - number value of protocol
VNS Commands (vnsmode)
Common Filter Configuration Commands
on page 245 or apfilters on page 245).
268