Siemens scalance WLC711 Reference Manual page 297

Parameters
radius
role acct|auth|mac
prot CHAP | PAP | MS-CHAP |
MS-CHAP2]
Usage
The command is not available when the authentication mode is guestportal. When the
config
authentication mode is disabled, MAC must be enabled for this command to be available. For
authentication
mode
mac on page 299.
For third party APs SSIDs, this command is only visible when mac is set to enable and only mac
authentication is supported.
After executing the
additional server attributes such as NAS ID and NAS IP address. When you are finished configuring
RADIUS server attributes, use the
context.
Example
The following example configures the RADIUS server "radius1" as an authentication server:
WLC.siemens.com
WLC.siemens.com
Current selected Radius server radius1 role auth
Priority Name
1 radius1
NAS identifier: Use VNS name
NAS IP address: Use VNS IP address
Authentication type: PAP
config exit
Use the
config exit
command is accessible from the wlans:<WLAN-service-name>:auth context of the CLI.
config exit
Parameters
None
Usage
Using the
config exit
the wlans:<WLAN-service-name>:auth RADIUS server configuration context and places you in the
wlans:<WLAN-service-name>:auth context.
SCALANCE WLC711 CLI Reference Guide
Specifies the name of the RADIUS server to configure
Specifies the role of the RADIUS server as accounting, authentication, or MAC
authentication server, respectively.
Specifies the Authentication type
command information, see
command to configure a RADIUS server, you can proceed to configure
config
command to return to the wlans:<WLAN-service-name>
exit
:wlans:cnl-AAA:auth# config radius1 role auth prot PAP
:wlans:cnl-AAA:auth# show
Role NAS IP
auth Use VNS IP address
command to exit the RADIUS server configuration mode. The
command from within the RADIUS server configuration command mode exits
mode on page 302. For
mac
NAS ID
Use VNS name
wlans Commands
config exit
command information, see
Auth Type
PAP
config exit
297