Parameters
add | delete
radius | local
Usage
•
You must configure the RADIUS server before you can add RADIUS-based authentication to the list.
To do this, use the
•
You cannot add duplicate authentication modes to the list.
•
The authentication order list must contain at least one authentication mode. You cannot delete an
authentication mode if it is the only mode in the list.
•
To change the order of authentication modes in the list, use the
173
Examples
The following example sets the login authentication to RADIUS-based mode:
WLC.siemens.com
WLC.siemens.com
Changing login mode will cause CLI to terminate. Do you want to proceed? y|
[n]:y
************************************************************
Login mode has changed. CLI will terminate in 5 seconds!
************************************************************
The following example sets the login authentication to the combination of local authentication first,
then RADIUS-based authentication:
WLC.siemens.com
1 authentication method: local
WLC.siemens.com
WLC.siemens.com
1 authentication method: local
2 authentication method: radius
move
Use the
command to change the order of authentication modes in the authentication mode
move
ordered list.
move order order
Parameters
order
SCALANCE WLC711 CLI Reference Guide
Specifies whether an authentication mode is to be added to or deleted
from the ordered list.
Specifies authentication mode to be added or deleted
commands. See
auth
auth
:login# auth-order add radius
:login# auth-order delete local
:login# show
:login# auth-order add radius
:login# show
Specifies the current priority of the authentication mode.
on page 170.
command. See
move
login Commands
move
move
on page
173