Siemens scalance WLC711 Reference Manual page 312
Hide thumbs
Also See for scalance WLC711:
- Getting started (100 pages) ,
- Compact operating instructions (30 pages) ,
- Maintenance manual (73 pages)
Table of Contents
Advertisement
Example
The following example enables the inclusion of Topology information in messages to the RADIUS
server:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
Topology as VSA attribute: enable
vsa-vns
Use the
command to include VNS information in the message to the RADIUS server. The
vsa-vns
command is accessible from the wlan:<WLAN-service-name>:auth context of the CLI.
vns
After you run the
vsa-vns
vsa-vns enable | disable
Parameters
enable | disable
Usage
The
command is not available when the authentication mode is guestportal. When the
vsa-vns
authentication mode is disabled, MAC must be enabled for this command to be available. For more
information, see
mode
Example
The following example enables the inclusion of VNS information in messages to the RADIUS server:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
VNS as VSA attribute: enable
backhaul-radio
Use this command to configure the backhaul radio band for a dynamic mesh WLAN service. The
command is accessible from the wlans:<WLAN-service-name> context of the CLI for
backhaul-radio
dynamic mesh type WLAN services.
backhaul-radio a|bg
Parameters
a
bg
SCALANCE WLC711 CLI Reference Guide
:wlans:test:auth# vsa-topology enable
:wlans:test:auth# apply
:wlans:test:auth# show vsa-topology
command, run the
apply
Specifies to enable or disable the inclusion of VNS information in
messages to the RADIUS server.
on page 302.
:wlans:test:auth# vsa-vns enable
:wlans:test:auth# apply
:wlans:test:auth# show vsa-vns
Select the 5 GHz radio band
Select the 2.4 GHz radio band
command to implement the changes.
wlans Commands
vsa-vns
vsa-
312
Advertisement
Table of Contents
