Siemens scalance WLC711 Reference Manual page 366
Hide thumbs
Also See for scalance WLC711:
- Getting started (100 pages) ,
- Compact operating instructions (30 pages) ,
- Maintenance manual (73 pages)
Table of Contents
Advertisement
Example
The following example shows a certificate request with a common name that is
an IPv6 address:
WLC.siemens.com
location CA Ontario Mississauga organization mnj_Ware_House Service email
me@email.com ipv6 key-size 2048
ip
Use the
command to specify the Wireless Appliance IP address and subnet mask for physical and
ip
routed topologies or the interface IP address and subnet mask for b@ac topologies. The
is available from the topology:<named-topology>:l3 context of the CLI for Admin, b@ac, physical, and
routed topologies.
ip A.B.C.D/0-32
Parameters
A.B.C.D/0-32
Example
The following example specifies an IP address and subnet mask:
WLC.siemens.com
ipv6
Use the
command to specify a management IPv6 address and subnet mask for the Wireless
ipv6
Appliance. The
ipv6
for the Admin topology only.
ipv6 A:B:C:D:E:F:G:H/0-64 | none
Parameters
A:B:C:D:E:F:G:H/0-64
none
Example
The following example specifies an IP address and subnet mask:
WLC.siemens.com
mgmt
Use the
command to allow or prohibit management traffic. The
mgmt
the topology:<named-topology>:l3 context of the CLI for b@ac, physical, and routed topologies.
mgmt enable | disable
SCALANCE WLC711 CLI Reference Guide
:ap:topology:Seg1_Routed:l3# gen_certreq [fd66:2280:2668::12]
Specifies the IP address and subnet mask.
:topology:r1:l3:# ip 10.109.0.1/30
command is available from the topology:<named-topology>:l3 context of the CLI
Specifies the IPv6 address and subnet mask.
Specifies that there is no IPv6 address configured for this controller.
:topology:Admin:l3:# ipv6 fd66:2280:2668::13/64
topology Commands
command
ip
command is available from
mgmt
ip
366
Advertisement
Table of Contents
