Chapter 20: Topology Commands; Create - Siemens scalance WLC711 Reference Manual

20
topology Commands

create

delete
internal-vlanid
multicast-support
show
<named-topology>
topology-group
This section describes commands used to define and configure topology objects used by policy and
VNS objects. These commands are located in the topology context of the CLI. Execute the
command at the root level to enter topology context.
All CLI commands cache changes. For this reason, sometimes when you make a change in a particular
context, the change may not be visible immediately. If this happens, you must exit and re-enter the
context in order to ensure that the database is synchronized with the latest change.
The following commands are available in the topology context:
•
create on page 340
•
delete on page 341
•
internal-vlanid
•
multicast-support
•
show on page 343
•
<named-topology>
topology:<named-topology> context.
create
Use the command to create a topology object. The
create
topology context of the CLI.
create topology name (b@ac <vlanid> port port name tag | untag) | (b@ap vlanid
tag | untag) | (routed A.B.C.D/0-32) | (physical vlanid) port port nametag |
untag> A.B.C.D./0-32)
Parameters
topology name
b@ac
b@ap
routed
SCALANCE WLC711 CLI Reference Guide
on page 342
on page 342
on page 343 — See
Specifies the name of the topology.
Specifies a Bridge Traffic locally at Controller topology.
Specifies a Bridge Traffic locally at Access Point topology.
Specifies a routed topology.
<named-topology> on page 343 for commands in the
create
topology
command is accessible from the
340