Siemens scalance WLC711 Reference Manual page 191

The following example adds channels 1, 3, and 9 to the scan profile:
WLC.siemens.com
WLC.siemens.com
classification
Use the
classification
command is accessible from the mitigator:scprof:<named scan profile> context and
classification
the mitigator:gsprof:<named guardian scan profile> context of the CLI.
After you run the
classification
classification (enable | disable)
Parameters
enable
disable
Example
The following example enables classification:
WLC.siemens.com
WLC.siemens.com
concurrent-number
Use the
concurrent-number
Guardian AP can concurrently launch countermeasures. The
accessible from the mitigator:gsprof:<named guardian scan profile> context of the CLI.
After you run the
concurrent-number
concurrent-number 1-4
Parameters
1-4
Usage
This command can be applied only to AP3715s. An AP3715 can concurrently launch countermeasures
on all channels it is scanning. As more countermeasures are applied and the number of channels to
which they are applied increases, the frequency of countermeasures being applied will decrease.
SCALANCE WLC711 CLI Reference Guide
:mitigator:scprof:scp_name# channels 1,3,9
:mitigator:scprof:scp_name# apply
command to enable or disable interference classification on this profile. The
command, run the
Enables interference classification on this profile
Disables interference classification on this profile
:mitigator:scprof:scp_name# classification enable
:mitigator:scprof:scp_name# apply
command to configure the maximum number of channels on which a
command, run the
The maximum number of channels on which countermeasures can be concurrently
launched. Valid values are not less than one, or greater than 4.
command to implement the change.
apply
concurrent-number
command to implement the change.
apply
Radar Commands
classification
command is
191