Text Conventions - Siemens scalance WLC711 Reference Manual

•
time Commands
Appliance, and configure network time protocol options.
•
traffic_capture Commands
•
users Commands
•
VNS Commands (vnsmode)
setup of virtual network services (VNS) for the network.
•
wlans Commands
for the network.
•
role Commands
Appliance.
•
topology Commands
objects used by policy and VNS objects.
•
Location-Based-Service (lbs) Commands
Wireless APs for use with an AeroScout or Ekahau location-based service.
•
web Commands
•
cos Commands
applied to policies.
•
site Commands
authentication server defined.
•
RF Location Commands
Frequency (RF) Location engine on a Wireless Appliance to determine location and perform
tracking on wireless mobile users through Wireless APs.
•
Publish Commands
Related Documentation
SCALANCE WLC711 documentation is available at:
Keyboard Shortcuts
There are several keyboard shortcuts available to assist in navigating within the contexts of the CLI.
•
To display options within a context or to complete partial entries of commands at the prompt, use
[CTRL] + I, [Tab], or the [?] key.
•
To transpose mi--typed characters at the command prompt, use [CTRL] + T.
•
To recall previous commands executed for the session, use the UP arrow.
•
To cycle forward through previously executed commands, use the DOWN arrow.

Text Conventions

The following tables list text conventions that are used throughout this guide.
SCALANCE WLC711 CLI Reference Guide
on page 224 describes commands to set the system time for the Wireless
on page 227 describes commands to manage the TCPDump.
on page 232 describes commands used to manage user accounts on the network.
on page 234 VNS Commands (vnsmode), describes commands for the
on page 275 describes commands used to define and configure WLAN services
describes commands used to define and configure policies for the Wireless
on page 340 describes commands used to define and configure topology
on page 377 describes commands used to configure the
on page 381 describes commands used to configure the web settings.
on page 384 describes commands for configuring Classes of Service that can be
on page 392 describes commands for configuring sites that have their own local
on page 409 describes commands used to enable and configure the Radio
on page 415 describes commands used in the publish context.
www.siemens.com/automation/service&support
About This Guide
Text Conventions
9