Chapter 21: Location-Based-Service (Lbs) Commands; Multicast - Siemens scalance WLC711 Reference Manual

21
Location-Based-Service (lbs)
Commands

multicast

port
service
server-ip
show
Related commands
This section describes commands used to enable and configure a location-based service on a Wireless
Appliance and Wireless APs. These commands are located in the lbs context of the CLI. Execute the
command at the root level to enter lbs context.
lbs
Aeroscout and Ekahau are the currently-supported location-based servers.
All CLI commands cache changes. For this reason, sometimes when you make a change in a particular
context, the change may not be visible immediately. If this happens, you must exit and re-enter the
context in order to ensure that the database is synchronized with the latest change.
The following commands are available in the lbs context:
•
multicast on page 377
•
port on page 378
•
service on page 378
•
server-ip on page 379
•
show on page 379
For information on related commands that are available in other contexts, see
page 380.
multicast
Use the
multicast
command is accessible from the lbs context of the CLI.
multicast 0x:0x:0x:0x:0x:0x
Parameters
0x:0x:0x:0x:0x:0x
SCALANCE WLC711 CLI Reference Guide
command to set the location-based server multicast address. The
Specifies the multicast address of the location-based server, in hexadecimal format.
Related commands on
multicast
377