Siemens scalance WLC711 Reference Manual page 284

Parameters
radio1 none | child | parent |
both
radio2 none | child | parent |
both
both none | child | parent |
both
pref-parent ap-name | Any
Parent
backup-parent ap-name | Any
Parent
wkgbridge off | on
Usage
This command is only available when the WLAN service type is WDS.
Example
The following example reflects the following:
•
AP Lancaster is serving as a child of AP Aruba on radio radio1
•
AP Auberon is the backup parent of AP Lancaster
•
Work group bridging is switched off
WLC.siemens.com
child radio2 parent pref-parent Aruba backup-parent Auberon wkgbridge off
WLC.siemens.com
aplist-wds (Mesh)
Use the
aplist-wds
command is accessible from the wlans:<WLAN-service-name> context of the CLI when
aplist-wds
the WLAN service type is mesh.
aplist-wds (WDS) on page 283 for information about using the command to configure a WDS type of
WLAN service.
aplist-wds ap-name (none|portal|mesh) [wkgbridge (on|off)] [radio1|radio2]
Parameters
ap-name
none|portal|mesh
wkgbridge (on|off)
radio1|radio2
SCALANCE WLC711 CLI Reference Guide
Specifies the AP's role on Radio1
Specifies the AP's role on Radio2
Specifies the AP's role on both radios
Specifies the AP's parent
Specifies the AP's backup parent
Configures the work group bridging
:wlans:shopfloor_WDS_wlan# aplist-wds Lancaster radio1
:wlans:shopfloor_WDS_wlan# apply
command to add an AP to a dynamic mesh type WLAN service configuration. The
Name of the AP being assigned to the WLAN service.
none = default, not assigned to the WLAN service.portal = the AP is a mesh portal
(equivalent to parent in static mesh WLANs).mesh = the AP is a mesh AP.
Configures the work group bridging
For a dual-band radio AP, if more than one available radio matches the backhaul
radio settings, select one of the radios for backhaul.
wlans Commands
aplist-wds (Mesh)
284