Siemens scalance WLC711 Reference Manual page 156

Example
The following example enables DHCP on the Wireless Appliance:
WLC.siemens.com
vlanid
Use vlanid to assign a VLAN tag to the subnet carrying the Wireless AP's management traffic. The
command is accessible from the ap:<serial> context of the CLI.
vlanid
vlanid 1-4094
Parameters
1-4094
Example
The following example assigns the subnet a VLAN tag:
WLC.siemens.com
wlan
Use the command to assign one or both of the AP's radios to the specified WLAN service. You
wlan
can also use this command to unassign the AP's radios from the specified WLAN service. The
command is accessible from the ap:<serial> context of the CLI.
wlan wlans name ( radio1 | radio2 | both | none )
Parameters
wlans name
radio1 | radio2 | both | none
Example
Example code is not currently available.
zone
Use the zone command to create a policy zone for the named Wireless AP. The command is accessible
from the ap:<serial> context of the CLI.
zone name
SCALANCE WLC711 CLI Reference Guide
:ap:0122003880188015# usedhcp
Specifies the ID tag for the VLAN
:ap:0122003880188015# vlanid 4
The WLAN service to which you want to assign the AP's radios or from
which you want to unassign the AP's radios.
Specifies the radios that you want to assign to the WLAN service. Use none
to unassign the radios from the WLAN service.
ap Commands
vlanid
wlan
156