Siemens scalance WLC711 Reference Manual page 308

Topology as VSA attribute: enable
Ingress rate control as VSA attribute: enable
Egress rate control as VSA attribute: enable
Interim interval (minutes): 0
Collecting accounting information of Wireless Controller: disable
With external: disable
Figure 2: Examples
use-policy-zone
Use the
use-policy-zone
command is accessible from the wlan:<WLAN-service-name>:auth context of the CLI.
policy-zone
After you run the
use-policy-zone
use-policy-zone enable | disable
Parameters
enable | disable
Example
The following example enables the policy zone on the test WLAN:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
Use policy zone name in Called-Station-Id: enable
vsa-ap
Use the command to include AP Identification in the message to the RADIUS server. The
vsa-ap
command is accessible from the wlan:<WLAN-service-name>:auth context of the CLI.
ap
After you run the
vsa-ap
vsa-ap enable | disable
Parameters
enable | disable
Usage
The command is not available when the authentication mode is guestportal. When the
vsa-ap
authentication mode is disabled, MAC must be enabled for this command to be available. For more
information, see mode
SCALANCE WLC711 CLI Reference Guide
command to enable or disable a policy zone at a called station. The
command, run the
Enables or disables the policy zone on this WLAN.
:wlans:test:auth# use-policy-zone enable
:wlans:test:auth# apply
:wlans:test:auth# show use-policy-zone
command, run the
apply
Enables or disables the inclusion of AP Identification information in
messages to the RADIUS server.
on page 302.
command to implement the changes.
apply
command to implement the changes.
wlans Commands
use-policy-zone
use-
vsa-
308