Siemens scalance WLC711 Reference Manual page 146

Example
WLC.siemens.com
Ontario Mississauga organization mnj_Ware_House Service email me@email.com
key-size 2048
peap
Use the command to set PEAP (Protected Extensible Authentication Protocol) authentication.
peap
Use the command to delete the PEAP authentication credentials from the Wireless AP. The
no
command is accessible from the ap:<serial>:802_1x context of the CLI.
peap user password
no peap
Parameters
None
Examples
WLC.siemens.com
aclist
Use the command to statically configure the IP addresses of Wireless Appliances for discovery.
aclist
Use the no form of the command to remove any IPs either by address or by rank. IP addresses removed
from the Wireless Appliance list are replaced in rank by the next listed IP address. Use the show
function to list the added Wireless Appliance IPs by rank.The
ap:<serial> context of the CLI. It is also available from ap:defaults if learnac is disabled (no learnac) in
that context.
aclist IP Address
no aclist rank | IP Address
Parameters
IP Address
rank
Examples
The following example adds three IP addresses to the Wireless Appliance list:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
SCALANCE WLC711 CLI Reference Guide
:ap:Ardal AP:802_1x# gen_certreq shopfloor_aps location CA
:ap:Ardal AP:802_1x# peap admin abc123
Specifies the IP address of the Wireless Appliance
Specifies the rank number of the listed Wireless Appliance
:ap:0409920201204003# aclist 6.178.34.54
:ap:0409920201204003# aclist 81.30.6.312
:ap:0409920201204003# aclist 167.232.92.39
command is accessible from the
aclist
ap Commands
peap
peap
146