Siemens scalance WLC711 Reference Manual page 407

Example
The following example enables secure tunnels between APs on site1:
WLC.siemens.com
WLC.siemens.com
secure-tunnel-control
Use the
secure-tunnel-control
between APs on this site and their controllers. The
from the site:<named-site> context.
secure-tunnel-control (enable | disable)
Parameters
enable | disable
Usage
The
secure-tunnel
be run.
Example
The following example enables secure tunnels between APs and controllers on site1:
WLC.siemens.com
WLC.siemens.com
secure-tunnel-lifetime
Use the
secure-tunnel-lifetime
hours the tunnel remains enabled) of this tunnel. The
accessible from the site:<named-site> context.
secure-tunnel-lifetime hours
Parameters
hours
Usage
The
secure-tunnel
be run. The default is 10 hours. When this value expires, the tunnel becomes disabled. Use the
command to terminate a tunnel.
tunnel disable
SCALANCE WLC711 CLI Reference Guide
:site:site1# secure-tunnel enable
:site:site1# secure-tunnel-ap enable
command to enable or disable the encryption of control traffic
Enables or disables secure tunnels between APs on this site and controllers.
command must be enabled before the
:site:site1# secure-tunnel enable
:site:site1# secure-tunnel-control enable
command to enable or configure the lifetime (the number of
Specifies the number of hours the tunnel will remain enabled.
command must be enabled before the
secure-tunnel-control
secure-tunnel-control
secure-tunnel-lifetime
secure-tunnel-lifetime
site Commands
secure-tunnel-control
command is accessible
command can
command is
command can
secure-
407