Siemens scalance WLC711 Reference Manual page 336

post-authentication timeout(minutes): 30
session timeout(minutes): 0
Block MU to MU traffic: disable
This example displays the settings for the dynamic mesh WLAN service named mesh1-wlan:
WLC.siemens.com
Service type: mesh
Pre-shared Key:
SSID: mesh1
Backhaul Radio Band: a
Name: mesh1-wlan
Enable/disable WLAN Service: enable
aplist-wds 0500008043050236
Radio Mode: off
ssid
Use the command to specify the Service Set Identifier (SSID) for the WLAN service being
ssid
configured. The
ssid
After you run the
ssid
ssid string
Parameters
string
Example
The following example specifies and then displays the SSID:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
SSID: testssid
status
Use the command to enable or disable this WLAN service. The status command is accessible
status
from the wlans:<WLAN-service-name> context of the CLI.
After you run the
status
status enable | disable
Parameters
enable | disable
SCALANCE WLC711 CLI Reference Guide
:wlans:mesh1-wlan# show
portal wkgbridge on
command is accessible from the wlan:<WLAN-service-name> context of the CLI.
command, run the
apply
Specifies a string for the SSID. The SSID string can range in length from 1 to 32
characters.
:wlans:test# ssid testssid
:wlans:test# apply
:wlans:test# show ssid
command, run the
apply
Enables or disables this WLAN service.
command to implement the changes.
command to implement the changes.
wlans Commands
ssid
336