Siemens scalance WLC711 Reference Manual page 390

Parameters
tos-dscp
mask
none
Usage
The slash (/) is a literal separator of <tos/dscp> and <mask> values.
Example
The following example configures a ToS-DSCP marking value (1E) and a mask value of FF:
WLC.siemens.com
rateprf-in
Use the
rateprf-in
a CoS. The
rateprf-in
rateprf-in profile | none
Parameters
profile
none
Usage
Refer to rateprofile
Examples
The following example configures the default-policy with the DocRateIn ingress rate profile:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
Assigned topology: guestPortal
Ingress rate profile: DocRateIn
Egress rate profile: Unlimited
Enable AP filtering: disable
Synchronize: enable
WLC.siemens.com
rateprf-out
Use the
rateprf-out
for CoS. The
rateprf-out
SCALANCE WLC711 CLI Reference Guide
Valid values, in hexadecimal., for ToS/DSCP are 0-FF.
Valid values, in hexadecimal., for mask are 0-FF.
ToS /DSCP values are not used.
:cos:my-cos# tos-dscp-mask 1E/FF
command to associate an already existing rate profile as an ingress rate profile for
command is accessible from the cos:<named-cos> context.
Specifies the ingress rate profile to configure for this wlans:default-cos context.
Specifies that the ingress rate profile is used for this wlans:default-cos context.
on page 262 for rate profile configuration information.
:cos:my-cos# rateprf-in DocRateIn
:cos:my-cos# apply
:cos:my-cos# show
:cos:my-cos#
command to configure an already existing rate profile for an outbound rate limit
command is accessible from the cos:<named-cos> context.
cos Commands
rateprf-in
390