Siemens scalance WLC711 Reference Manual page 359

Example
The following example defines the DHCP range of IP addresses:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
show
Use the command to display DHCP information for the specified topology. The
show
available from the topology:<named-topology>:l3:dhcp context of the CLI for b@ac, physical, and
routed topologies.
The output of the
show
show
Parameters
None
Examples
Example code is not currently available.
wins
Use the command to specify the IP address for the Windows Internet Naming Service (WINS)
wins
server. The command is available from the topology:<named-topology>:l3:dhcp context of the
wins
CLI for b@ac, physical, and routed topologies. This command is visible only when mode is set to local.
See mode on page 358.
After you run the
wins
wins (WINS server [,WINS server [...]]) | none
Parameters
WINS server [,WINS server
[...]]
none
Examples
The following example specifies the IP addresses of two WINS servers:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
SCALANCE WLC711 CLI Reference Guide
:topology:routed2:l3:dhcp# mode local
:topology:routed2:l3:dhcp# range 192.168.1.30 192.168.1.54
:topology:routed2:l3:dhcp# apply
command is determined by how mode is set. See
command, run the
apply
Specifies the qualified IPv4 IP address or name of one or more WINS
servers.
Clears the IP addresses and indicates that no WINS server is present.
:topology:r1:l3:dhcp# mode local
:topology:r1:l3:dhcp# wins 192.168.1.3, 192.168.1.4
:topology:r1:l3:dhcp# apply
mode
command to implement the changes.
topology Commands
show
command is
show
on page 358.
359